Well I finished my latest foam board jet project yesterday and maiden the XF-18 this afternoon. Basically it is a slightly modified Parkjet.com F-18 that I have blown up to about 150%.
It has a 41" wingspan and is about 61" in length. I am using a Turnigy 3648 motor with 1450KV, 60 amp Exceed Volcano ESC and a 2200 4S 30C battery. Currently I have a 7X6 TGS prop on it which makes it pull about 55 amps. This set up gives it a 1:1 power ratio using about 3/4 throttle.
Using just elevons it does extremely tight loops but roll rate is smooth but slow. I will probably add ailerons in the future. Now that it has successfully flown I will either go up to a 5S battery or go to a 8X6 prop to get some addition speed and thrust. Either change will require at least an 80 amp esc. I need to take it slow since the only reinforcement to the foam is a single 3mm carbon fiber ribbon to stop wing flexing.
Resource for remote controlled foam aircraft pilots. Tips for building, controlling, and buying foam airplanes.
Tech One Swift
Tech One Swift
Friday, December 3, 2010
Wednesday, November 17, 2010
One more attempt at EDF
Well I took the Hangar Queen (Max F-117 Camo)out last weekend and tried one more time to get it air borne. It finally took off after reworking the landing gear and drilling new holes on the elevon horns to increase upward travel.
It was able to do a few slow rolls but no loops even at full throttle. Just like it stalled out trying to do loops it stalled again landing and damaged landing gear beyond repair. Without landing gear and unable to be hand launch I trashed it for EDF and electronics.
Have now mounted EDF and electronics on a new foamboard jet. In process of checking amp draw, found out that ESC was not allowing for full load. Reset throttle throw setting several time with no increase. It would appear that it was about 25% off maximum (258watts vs 200watts) when compare to another ESC off another EDF jet. Might have been the problem with the F-117 all along.
Should be able to maiden new jet this weekend. It has little more than a 1 to 1 thrust ratio which should allow for hand launch
Saturday, October 30, 2010
All Quite on the RC Front
Not much happening lately. No new planes/jets to report on. Have about 30 flights on the MegaJet II with no crashes. Jonnie has reworked his Giant SR-71 and added stearable landing gear making it possible to take and land in the parking lot when empty.
Have a more powerful motor for the MegaJet II but enjoy flying it right now with the existing motor. The additional speed would be nice but it would cut my fling time in half if I prop it out as planned.
FYI Jonnie's experience with the new Turnigy Nano batteries has been less than desirable. It would seem they don't like being pushed to their burst limit. He has fried both of the Nano's but regular batteries pushed to their stated limits seem to hold up. It would seem that the Nano's double the normal rating for a burst limit is over optimistic.
Have a more powerful motor for the MegaJet II but enjoy flying it right now with the existing motor. The additional speed would be nice but it would cut my fling time in half if I prop it out as planned.
FYI Jonnie's experience with the new Turnigy Nano batteries has been less than desirable. It would seem they don't like being pushed to their burst limit. He has fried both of the Nano's but regular batteries pushed to their stated limits seem to hold up. It would seem that the Nano's double the normal rating for a burst limit is over optimistic.
Monday, September 20, 2010
Flying High and Large
Well we finally had good weather this weekend for a change. No wind and upper 80's made flying a joy. Only down side was fighting off the mosquitoes at dusk. Been a while since so many people showed up for flying.
Jonnie brought out and maiden his giant SR-71. It has a 36" wingspan and is 60" nose to tail. The only casualty after several successful flights was a puffed up battery. He was pulling too many amps for the 2200mah 4S Nano-Tech battery. With an 8X6 prop he was pulling close to 1,000 watts at WOT. Several changes are in the works to get the full 1500 watts that the motor is capable of handling.
Hopefully the dark days are just about over for me. I have been without a good transmitter for over 3 weeks. My Spektrum DX6I is due back this week so I can launch my MegaJet F-22 with Jonnie's Giant SR-71. Should be fun seeing these two monster foamies this up coming weekend.
Speaking of dark days there are not too many days left for flying after 6 pm without lights. Everyone is or needs to be ramping up with leds to extend our night flying.
Sunday, September 19, 2010
Everyone was up!
Finally had some good flying weather this weekend except for the mosquitoes. We are trying to figure out a way to mount a receiver on one of them to see how well they fly. We will need 6 channels receiver to have functioning blood sucker and retractable landing gear.
Everyone was flying Sunday night. Jonnie launched his new improved SR-71. This monster is approximately 60" in length with a 38" wingspan. He completed several successful flights with no problems other than a puffed 4S nano-tech lipo battery. It needs a higher capacity battery to handle extended high speed runs. Should have video soon.
I crumpled a couple of older foamies this week using the cheap radio that came with an EDF jet. Can't wait for my DX6I to arrive back this week from the repair shop. You can fly with those cheap radios but you can't get too attached to the planes your flying on them. The receivers seem to have a problem with emf off the motors. Had to be careful when coming off throttle because elevons would jump then reset. Not a problem when at 50 feet but deadly
Everyone was flying Sunday night. Jonnie launched his new improved SR-71. This monster is approximately 60" in length with a 38" wingspan. He completed several successful flights with no problems other than a puffed 4S nano-tech lipo battery. It needs a higher capacity battery to handle extended high speed runs. Should have video soon.
I crumpled a couple of older foamies this week using the cheap radio that came with an EDF jet. Can't wait for my DX6I to arrive back this week from the repair shop. You can fly with those cheap radios but you can't get too attached to the planes your flying on them. The receivers seem to have a problem with emf off the motors. Had to be careful when coming off throttle because elevons would jump then reset. Not a problem when at 50 feet but deadly
Friday, September 3, 2010
Slow and Painful week
Weather has not been good for flying the last couple of weeks. Wind and rain has limited my flying time. Then I went and dropped my DX6I radio this week and put it out of commission.
Still doing a limited amount of flying using a 2.4 GHz radio that came with a EDF jet purchased recently. Limited in the fact that this radio seems to have a mind of its own every now and then. It was responsible for the demise of the JeTiger and has tried to eliminate my scratch built foamies a couple of times. They were better handling so I was able to save them before hitting the ground. I'll take a prop pusher over an EDF jet everytime when it comes to using thrust to overcome gravity.
On a more positive note, I have completed all the changes to the MegaJet II. When I get my DX6I repaired I will take it out. I was able to put a 9X6 prop on it and still have over a 1 to 1 thrust ratio. It also dropped the watts down to around 450 which is good. Motor sounds like it is producing higher rpms so I should be able to get a little more speed. Hope the airframe can handle it since I used a limited amount of carbon fiber on the wings.
Still doing a limited amount of flying using a 2.4 GHz radio that came with a EDF jet purchased recently. Limited in the fact that this radio seems to have a mind of its own every now and then. It was responsible for the demise of the JeTiger and has tried to eliminate my scratch built foamies a couple of times. They were better handling so I was able to save them before hitting the ground. I'll take a prop pusher over an EDF jet everytime when it comes to using thrust to overcome gravity.
On a more positive note, I have completed all the changes to the MegaJet II. When I get my DX6I repaired I will take it out. I was able to put a 9X6 prop on it and still have over a 1 to 1 thrust ratio. It also dropped the watts down to around 450 which is good. Motor sounds like it is producing higher rpms so I should be able to get a little more speed. Hope the airframe can handle it since I used a limited amount of carbon fiber on the wings.
Monday, August 23, 2010
Slow Week
Not much happening the last week. Only flew a couple times with temperatures well over 100 at 8:00 in the evening. Built a couple new jets this week. One looks similar to the F-15 and another has it own look. Both were rigged with Turnigy 2836 motor w/2350kv (6X4 prop). Matched with a 60 amp Vocano ESC and 4S30C 2200mah BlueLipo battery. Maiden flights were trouble free.
On another note, I have ordered new larger metal gear servos for the MegaJet II. Had insufficient torque on previous servos to perform any stunts other than a few slow rolls. Also going to go to a smaller prop(9x6) with more pitch to increase speed. Hoping to get something near 60 mph in the future.
On another note, I have ordered new larger metal gear servos for the MegaJet II. Had insufficient torque on previous servos to perform any stunts other than a few slow rolls. Also going to go to a smaller prop(9x6) with more pitch to increase speed. Hoping to get something near 60 mph in the future.
Subscribe to:
Posts (Atom)